How To Flash Stock ROM Firmware Using Smart Phone Flash Tool

There are instruction to Flash Stock Rom are any custom Rom using Smart Flash Tool (sp Flash Tool) on windows computer.

Requirement: Your Android Smartphone Should have been at-least 40-50 percent of battery to perform flashing process.

Flash Stock ROM Firmware Using Smart Phone Flash Tool

Step 1: Download the stock ROM zip file and extract it on your computer. Now download SP flash tool, after download install it on your computer.

Step 2: Now download USB driver and install it on your computer. In case if you have already installed USB driver on your computer skip this step.

Step 3: Next, switch off your Android smartphone and remove the battery (If it is removable).

Step 4: Now go to the extracted folder in Step 1 and open up the SP Flash Tool sub-folder. You will find “Flash_tool.exe” file in it. Launch it.

Step 5: Once SP Flash tool is launched, click on “Download” tab.

Step 6: Now, click on “scatter-loading” button in the download tab.

Step 7: Next, click on “Open Scatter File” and select the scatter file from Step 1. For reference see the image given below.

Step 8: Now click on the “Download” button to start the flashing process.

Step 9: Next, connect your Android device to your computer through original USB cable (without battery – if it is battery removable) and press volume up or volume down button.

Step 10: The flashing process will begin momentarily, and it will get completed in a minute or two. Once it is over, you will see the “Download OK” green ring in SP Flash Tool.

Step 11: Now, close SP Flash tool on your computer and unplug your smartphone.

That’s it. Now you have successfully flashed stock ROM firmware on your Android device. If you encounter any issues while following this tutorial, do let me know via comments.